AUTONET TV

Cold Weather Vehicle No-Nos (Items to Avoid Storing in a Freezing Vehicle)

It's always easier to leave a few things in your vehicle so you'll have them on hand.  But in cold weather, while it's a good idea to carry items such as a phone charger, blanket and shovel, there are some things you shouldn't store in your vehicle.

• Medicines and drugs.  Cold temperatures can affect the chemical makeup of some drugs.  Avoid leaving them in a vehicle, especially those in a liquid form like insulin, eye drops and cough syrup.
• Latex paint.  They are water based, and when they freeze, they get lumpy and lousy.  Your paint job will not be what you had in mind.
• Cellphones and computers.  Most of these have lithium ion batteries.  If they get colder than freezing (0 degrees C, 32 degrees F), if you try to charge them, you'll more than likely ruin the batteries. 
• Bottled water, soda, wine or beer.  OK, here's the scoop.  All of these can freeze and split the container they're in.  Yes, soda, wine and beer will take a lower temperature to freeze than water, but all of these can easily freeze if the mercury plunges low enough.  The problem isn't when they're frozen; it's when they unfreeze, drip out of their containers and leave you with a colossal mess. 
• Musical instruments.  Guitars are made of wood.  When a guitar freezes and you bring it quickly into a warm room, you may hear cracking sounds that tell you that guitar will be not-so-gently weeping from the damage that can occur.  The same goes for wind instruments and others.  Don't ever subject musical instruments to quick temperature extremes.

Take a little time and effort not to leave these things out in a frigid vehicle.  You'll likely spend far more time and money tending to the resulting consequences than if you'd just brought them inside in the first place.

Madison Automotive
2457 Covington Pike
Memphis, TN 38128
(901)386-9600
http://www.madisonautomotive.net

Bump in the Road (Alignment)

There's something you can do that helps your tires last longer, wear more evenly and your vehicle handle better.  "Sign me up," you say! Wondering what that is? It's aligning your wheels, and it will literally point you in the right direction when it comes to a better and safer driving experience.

When your vehicle was designed, the engineers made sure your tires were all pointing the same way by designing the suspension to make optimal contact with the road. That way the ride is smooth, you don't feel vibrations or shimmying and your vehicle travels in a straight line, without pulling to one side or the other.

Unfortunately, your vehicle is not brand new; time and distance take their toll.  After hitting countless bumps, potholes, or the occasional curb, your suspension gets knocked a little out of kilter.  Those precise angles the engineers planned on for your vehicle? They get out of whack

Uneven or premature tire wear is one of the first signs your alignment may be off.  If you are driving straight and your steering wheel isn't pointing straight, that's another indication alignment might need checking. Tire squealing can also be a clue.

When you bring your vehicle in for an alignment, we use equipment designed to measure the tilts and angles of your suspension's parts.  The technician will also check to see if any of the vehicle's suspension components are worn or broken.  We will also check your steering angle sensor to make sure it's set properly. 

The process is different for vehicles that are front-wheel drive, rear-wheel drive, all-wheel drive, or 4-wheel drive. 

After your alignment, your tires should wear more evenly, your steering should be straight and your wheels vibration-free.  If it's been a while since you've had your vehicle aligned, bring it in and we'll check it.  Usually, your alignment will be a little off after one or two years of driving, and it's wise to follow your vehicle manufacturer's recommendation for how often your model should be checked.

Madison Automotive
2457 Covington Pike
Memphis, TN 38128
(901)386-9600
http://www.madisonautomotive.net

Start Me Up (Ignition Systems)

When you start up your gasoline engine car, you may not know that it's using the same ignition principles as it has for decades.  You have spark plugs that require enough power so a spark can jump across a gap at its tip.  Years ago, a vehicle's 12-volt system had to produce 15,000-25,000 volts to do that, so engineers came up with something called an ignition coil that bumps up the voltage. It also has to be done at just the right interval called timing.

The first systems had a distributor, a mechanical device with a rotating disc that switched the power to the ignition coil on and off.  That higher voltage then was sent to the spark plugs at the correct time interval. But the mechanical "points" had to be replaced and adjusted every 12,000 miles/20,000 kilometers.  Engineers later replaced the switching mechanism with solid state ones, but they still needed replacement after 120,000 miles/200,000 kilometers.

The next evolution came in the 80's when the distributor was replaced with a couple of sensors which talked to a computer.  This "DIS" (distributor-less automotive ignition system) was a big advance.  Plus, it didn't use just one ignition coil for all the cylinders.  It had coil "packs" that each provided spark to two cylinders.  That way, the voltage could be boosted even higher, to 30,000 volts, which helped engines be able to ignite a leaner fuel/air mixture.

Recently have come even more improvements.  Now instead of coil packs, there's a coil that's attached to each spark plug.  No more spark plug wires means less maintenance. Plus, a stronger, hotter spark of 50,000 volts can make an engine more reliable, increase fuel economy and reduce emissions.

No matter what ignition system your vehicle uses, your vehicle service facility has a staff of technicians trained to work on the latest technology.  Make sure to have your vehicle maintained regularly so you can take full advantage of these modern engineering marvels.

Madison Automotive
2457 Covington Pike
Memphis, TN 38128
(901)386-9600
http://www.madisonautomotive.net

A Sticky Brake Situation (Parking Brake Service and Maintenance)

We've all been there.  You park your vehicle on a steeper than usual hill and worry about it rolling down while you're running your errands.  So you decide you'll use the parking brake.  When you get back, you release the parking brake, hit the ignition, put it in gear and—uh, oh—you can feel the parking brake is still on.  It's stuck.  What do you do now?

Welcome to the world of infrequently-used parking brakes.  Yes, they do stick for several reasons. It's common for components to corrode and get locked up.  Sometimes if you have applied it extra hard, it can jam.  Could be a rusty cable, could be a spring that doesn't return the brake to its disengaged position.  Some pieces just break when they're stressed for the first time in a while. A caliper or the pivot arm it's on can also stick.

There are a few things you can try to unstick it.  Carefully rock your vehicle by putting it first in drive and then reverse.  You have to be careful doing that, though, because sometimes you can damage the transmission.  You can try working the parking brake control a few times to see if that will loosen the corrosion.  If you can't unstick it, you can try driving slowly a short distance to a repair facility near you.  Sometimes it won't cause damage to the brakes but it depends on how tightly the parking brake was applied and what was stuck.  You may also have to have your vehicle towed to a repair facility.

In any case, once you've seen these symptoms, have your vehicle brakes looked at by a professional who can fix the root of the problem.  Better yet, don't let your vehicle get in this condition; regular maintenance and inspections by a trained technician should prevent you from getting in a jam somewhere thanks to a stuck parking brake.  You could use a "brake" like that.

Madison Automotive
2457 Covington Pike
Memphis, TN 38128
(901)386-9600
http://www.madisonautomotive.net

Growing Old Together (Maintaining an Older Vehicle)

More and more of us are hanging on to our vehicles longer.  A company by the name of HIS Markit recently released a report that shows the average age of light vehicles in the U.S. is now 11.8 years.  Light vehicles are cars, SUVs (sport utility vehicles) and CUVs (compact utility vehicles). 

In Canada, the average life expectancy of a vehicle there is around 13 years, and in the U.S., it's around 15.  Vehicles are lasting longer these days, and there are several reasons for that.

One expert cites better technology and overall quality improvements.  While in past years, vehicles were made mainly of heavier steel components, more modern vehicles contain lighter magnesium and aluminum alloys, high-strength steel, polymers and carbon fiber.  They last longer and reduce the overall vehicle weight, and that can contribute to better fuel economy.

Modern internal combustion engine designs have been improved, and since they use more computers, they are more efficient with better performance.  Those factors also contribute to a longer-lasting powertrain.  In fact, it's not unusual to see a powertrain easily last 150,000 miles/250,000 kilometers or more with no major failures.

Drivers are also taking their vehicles in more regularly for periodic maintenance.  Choosing one service facility for all your maintenance can contribute to your vehicle's longevity, too, since technicians know your vehicle's repair and service history.

If you bought your vehicle taking out a 5-year loan and you keep it 11 years, you've managed 6 of those years without a payment, always a nice feeling.  Plus, a bonus is that you get very familiar with every aspect of that vehicle's sounds, smells, handling, stopping characteristics, visibility and limitations.  And the more familiar you are with your vehicle, the more confident you can be as a driver.

Madison Automotive
2457 Covington Pike
Memphis, TN 38128
(901)386-9600
http://www.madisonautomotive.net